
T310 / T320 / T330 / T340
Applications:
• soft insoles with foam or EVA
• lining strains and heels
• lining shoes and belts
• belts type soleta
• scholarships
• strappy sandals
• twisted, fillets, among others.
• Label
• crafts
• diary covers
• blocks
• furnishings and office
Thickness:
0.3mm; 0.5mm; 0.75mm; 1.0mm; 1.2mm; 1.4mm; 1.6mm; 1.8mm; 2.0mm; 2.50mm; 3.0mm; 3.5mm
Mass color:
Natural (310, 320, 330, 340); chromium (342); Black (314, 324, 334, 344) and coffee (345).
Technical Data:
• Stretching - DIN 53328. Unit%. It is the elongation percentage of the material on the initial length of the specimen, to the breaking of it, when subjected to tensile force.
Specification: There is no specification for this application, the contents are guidelines for maintaining quality standards. Minimum 40%.
• Tensile strength - DIN 53328. Each N / mm². Determines the tensile force per unit area required to break the material pre-established specimens.
Specification: There is no specification for this application, the contents are guidelines for maintaining quality standards. Minimum Tensile strength 150 N.
• Butchery - DIN 53506. Unit kg / cm. Determines the force required to continue the tearing starting from an initial punch, elongated. Its importance is to check the strength of the material from perfuros.
Specification: There is no specification for this application, the contents are guidelines for maintaining quality standards. Minimum 30 kg / cm.
• continuous Pushups - SATRA Method PM 3. Determines the number of continuous bending at an angle of 180 ° the material holds up to the total disruption, subjected to tensile force of 10 N.
Specification: There is no specification for this application, the contents are guidelines for maintaining quality standards. Minimum 2,000 continuous push-ups.
• punch resistance to fatigue buckle - Recouro method. N. Unit consists of submitting the specimen, the application of dimensions, tensile strength, where the buckle through the punch. The punch must resist at least 200 N damage without pulling force. \
Specification: The punch must resist at least 200 N damage without pulling force.
• Friction fastness of the dyeing and finishing - DIN 53339 / 1978. finishing Determination of resistance in friction Veslic apparatus where a standard tissue under constant weight rubbing the material to be tested. This fabric can be dry or soaked in water or artificial sweat solution. Is achieved so verify that the finish is coming out, staining the tissue and or damage occurs in the finish. The result is obtained by comparative analysis of the fabric dyeing, in relation to the white zone of the same, with Gray Scale.
Specification: There is no specification for this application, the contents are guidelines for maintaining quality standards.